How to pass a proxy address during OneAgent installation on Windows
The Windows installer allows you to enter a proxy address during installation, so in the majority of cases you don't need to worry about adding extra command line parameters. Command line parameters are particularly useful when you're deploying a Group Policy installation or other automated task.
The OneAgent installer recognizes the
--set-proxy parameter. The value of the parameter is the proxy server address. Add the port number following a colon (for example,
220.127.116.11:8080). For an authenticating proxy, you can specify the username and password like this
username:firstname.lastname@example.org:8080, where both username and password need to be URL encoded. Dynatrace also supports IPv6 addresses.
Parameter names are case-sensitive, so use
ALL CAPS for parameter names.
Passing a proxy address to the installer
Let's say you've downloaded your OneAgent installer to the
C:\Users\Admin\Downloads folder and your proxy IP address is
10.1.1.5. In such a scenario you would begin the installation like this:
Change proxy after installation
If you need to change the proxy address after installation, use
--set-proxy in the OneAgent command-line interface.