Customize ActiveGate installation

Command line parameters can be used with the Linux installer as follows:

Dynatrace-Security-Gateway-Linux-<version>.sh [parameter] [<parameter1>=<value2>] [<parameter2>=<value2>] ...

Note: Spaces between the parameter name and parameter value aren't allowed.

Parameter Meaning
PROXY=<proxy_address>:<proxy_port> Proxy
USER=<user> Runs service as a specified user. For versions below 1.155, the user must exist in the system. For versions 1.155 and above, the installer creates the user if it doesnt't exist in the system and this user doesn't require the root rights. If the parameter is not specified, the installer creates the dtaguser to run the ActiveGate service. You can however use USER=root to force ActiveGate service to run as root.
INSTALL=<folder> Stores binary files in the specified folder. The default value for this parameter (if not specified) is /opt/dynatrace/gateway. Not permitted during upgrade.
LOG=<folder> Stores log files in the specified folder. The default value for this parameter (if not specified) is /var/log/dynatrace/gateway. Not permitted during upgrade.
CONFIG=<folder> Stores configuration files in the specified folder. The default value for this parameter (if not specified) is /var/lib/dynatrace/gateway. Not permitted during upgrade.
TEMP=<folder> Indicates the temporary directory to be used by ActiveGate. The default value for this parameter (if not specified) is /var/tmp/dynatrace/gateway. Not permitted during upgrade.